FHOO1 Horn Speake.
The
Ferguson Hill Loudspeakers are full range units from 150Hz - 20KHz,
with no crossover, however, a sub bass unit is required below 150Hz.
They reproduce music with a high level of clarity, detail and dynamics,
are highly efficient, and will go loud with just a few watts (5
watts).This allows their use with relatively low powered amplifiers
further increasing the level of clarity obtainable, from such
relatively 'simple' amplifier circuits.The stands are a welded
stainless steel construction, satin polished, with internal damping,
integral spikes, supplied with floor protector discs.The horns are made
from toughened cast acrylic, precision moulded, 8mm thick.The support
ring and phase plug are precision machined from aluminium alloy, and
have a protective anodised finish.The drive unit is a modified Lowther
DX3 full range driver.They require a sub bass/sub woofer from 150 Hz
down, with level control, ideally taking the signal from the preamp
stage.Recommended amplifier power, 3 to 50 watts, they are ideally
suited to low power valve amps, and also work well with high quality
transistor amps. (A demonstration with your chosen amp is highly
recommended).
Ferguson Hill Loudspeakers are full range units from 150Hz - 20KHz,
with no crossover, however, a sub bass unit is required below 150Hz.
They reproduce music with a high level of clarity, detail and dynamics,
are highly efficient, and will go loud with just a few watts (5
watts).This allows their use with relatively low powered amplifiers
further increasing the level of clarity obtainable, from such
relatively 'simple' amplifier circuits.The stands are a welded
stainless steel construction, satin polished, with internal damping,
integral spikes, supplied with floor protector discs.The horns are made
from toughened cast acrylic, precision moulded, 8mm thick.The support
ring and phase plug are precision machined from aluminium alloy, and
have a protective anodised finish.The drive unit is a modified Lowther
DX3 full range driver.They require a sub bass/sub woofer from 150 Hz
down, with level control, ideally taking the signal from the preamp
stage.Recommended amplifier power, 3 to 50 watts, they are ideally
suited to low power valve amps, and also work well with high quality
transistor amps. (A demonstration with your chosen amp is highly
recommended).
Speaker dimensions
Height 1.65m
Width 0.92m
Depth 0.72m
Specification
Drive unit: Modified Lowther DX3
Sensitivity 1M/1KHz/1 watt 100db
Nominal impedance 8 ohm
Weight 27 Kg each without damping fill.
No comments:
Post a Comment